Risco Agility Installer Manual


AgilityInstallerManual
Page 4-64
Testing menu
Thefollowingmenuisusedtoperformtestsonthesystem.Notethateachtestreferstothe
lasttimethedevicewasactivated.Testscanbeperformed onthefollowingelements:
1.MainUnit
2.Zone
3.RemoteControl
4.Keypad
5.Siren
6.GSM
7.IPUnit
8.UO
Unit
1. Main Unit
Main Unit
Parameter Default Range
NoiseLevel
 
Measurethecurrentnoiselevelbythesystemreceiver.
Siren
 
Activatesthemainunitsiren.
Speaker
 
Soundsthelocaltestmessage:“Testmessage”.SelectStarttoactivatethefeature.Select
Stoptoendthetest.
Battery
 
Displaysthebatteryvoltageofthemainunit.
Version
 
Displaysthesoftwareversion.
2. Zone
Zone
Parameter Default Range
CommTest
 0‐99
Displaystheresultsofthelastmeasurementperformedafterthelasttransmission(last
detectionorlastsupervisionsignal).Toreceiveanupdatedsignalstrength,activatethe
detectorpriortoperformingthecommunicationtest.
BatteryTest
 
Displaystheresultsofthelastbatterytestperformedafterthelasttransmission.OK
messageisdisplayedforasuccessfultest.Foranupdatedvalueactivatethedevice.

Risco Agility Specifications

General

Remote Management	Yes
Mobile App	Yes
Voice Module	Optional
Backup Battery	Yes
Two-Way Voice	Yes
Event Reporting	Yes
Remote Control	Yes
Siren Output	Yes
Type	Wireless
Communication	GSM
Compatibility	Risco accessories
Power Supply	Mains powered with battery backup