Risco Agility Installer Manual

 AgilityInstallerManual
Page 3-4
Wireless Device Allocation
Eachwirelessdevicemustidentifyitselftothesystemreceiver.Thefollowingsection
describesthedifferentwaystoallocateallofyourdevicestothesysteminordertolater
configureeachdeviceʹsparameters
Thelearningprocedurebetweenyou’rethewirelessdevicesandthemainunitcanbe
performedeither
fromthemainunit,awirlesskeypadorviatheConfigurationSoftware.
Quick Allocation using the main unit button
Toperformquickallocationusingthemainunitbutton,followthisprocedure:
Note:ToenableQuickAllocationmodetheSystembitʺQuickLearnʺshouldbeenabled.
1. SetthemainunittoLearnmodewithalongpressonthemainunitbutton.Each
LEDwilllightuponeafteranother.
Note:TheunitwillsoundeachtimeyouenterorexittheLearnmode.
2. Sendatransmissionfromeachdevice(refertotheTransmitterswritemessage
methodtableinsection).Thesystemwillautomaticallyidentifyeachdevice
accordingtodifferentcategories(forexample:detectors,sirens,keypads,remote
controlsetc.)andentereachdeviceanditsdefaultvalue intotheunitʹsmemory.
Eachdevicereceivesanindexnumberfromthesystem.
3. ExittheLearnmodewithashortpressonthemainunitbutton.
Allocation using the keypad
Itispossibletoperformallocationviathekeypadintwodifferentways:RFAllocationor
byenteringthedevice’sserialcode.
ToperformRFAllocationviathekeypad,
followthisprocedure:
1. GototheInstallermenusandselectProgrammingÆRadioDeviceÆAllocation
ÆRFAllocation.ThesystemimmediatelygoesintoLearnmode.
2. Sendatransmissionfromthedevice.(Seetable:Transmitterswritemessagemethod)
3. Themainunitwillacknowledgethetransmissionwitha
sound.Whenthesystem
recognizesthedevicethekeypadLCDwilldisplaythedeviceʹsserialnumberand
category.Thesystemalsoautomaticallyallocatesthedevicethenextavailable
indexnumber.
Toperformallocationviathekeypadusingaserialcode,followthisprocedure:
1. GototheInstallermenus
andselectProgrammingÆRadioDeviceÆAllocation
ÆByCode.Enterthedevice’s12digitserialcodenumber.
2. Thesystemautomaticallyrecognizesthedeviceandallocatesitthenextavailable
indexnumber.Thesystemwillsoundthedevicetypethathasbeenallocatedand
theplaceithasbeen
allocatedto.

Risco Agility Specifications

General

Remote Management	Yes
Mobile App	Yes
Voice Module	Optional
Backup Battery	Yes
Two-Way Voice	Yes
Event Reporting	Yes
Remote Control	Yes
Siren Output	Yes
Type	Wireless
Communication	GSM
Compatibility	Risco accessories
Power Supply	Mains powered with battery backup