Risco Agility Installer Manual


AgilityInstallerManual
Page 4-36
I/O Expander: Output Parameters
Parameter
Activation/Deactivation
 
Whentheutilityoutputisfollowingmorethanonepartitionorzone,theinstallercan
choosethelogicoftheUtilityOutputactivationasfollows:
 IfthepatternoperationoftheoutputisdefinedasLatchN/OorLatchN/C,th e 
activationanddeactivationoftheoutputscanfolloweitheraft e r allthe
Partitions/ZonesorafteranyofthePartitions/Zones.
 IfthePatternope rationofth e outputisdefinedasPulseN/OorPulseN/ C,the
activationofthe outputscanfolloweitherafterallthePartitions/Zonesorafterany
ofthePartitions/Zones.Thedeactivationoper a tionfollowsthedefinedtimeperiod.
PulseDurationLength
05sec 01‐90
ThetimethatanoutputdefinedasPulsedN.OorPulsedN.Cwillbeactivated.Atthe
endofthepulsedurationtheoutputreactivatesautomatically.
X‐10Outputs
ThewirelessI/OexpanderenablesthesystemtocontrolX–10devices.TheI/Oexpander
convertstheinformationsentfromtheprogrammableutilityoutputintotheX–10
protocol.UptosixteenX‐10devicescanbeactivated.Thesearerecognizedinthesystemas
outputs5‐20.
I/O Expander: X-10 Outputs
Parameter Default Range
Label
 
Alabelidentifiestheoutputinthesystem
Type
 
Refertotheexplanationundertheutilityoutputsection.
Pattern
 
Refertotheexplanationundertheutilityoutputsection.
PulseLength
05sec 01‐90
Refertotheexplanationundertheutilityoutputsection.

Risco Agility Specifications

General

Remote Management	Yes
Mobile App	Yes
Voice Module	Optional
Backup Battery	Yes
Two-Way Voice	Yes
Event Reporting	Yes
Remote Control	Yes
Siren Output	Yes
Type	Wireless
Communication	GSM
Compatibility	Risco accessories
Power Supply	Mains powered with battery backup