107 • Chapter 5: User Mode and Calibration GX-3R Pro Operator’s Manual
3. Use AIR to display the desired setting.
4. Press and release POWER MODE to save the setting and return to the Confirmation Menu.
5. See “ESCAPE” on page 108 to return to User Mode.
BEEP INTERVAL
The BEEP INTERVAL parameter defines how often the confirmation alert or non-compliance
indicator selected in BEEP SELECT occurs. This setting only applies if the BEEP SELECT
parameter is set to something other than OFF. The available choices are 0.5 minutes and 1-99
minutes in 1 minute increments. The factory setting is 5 minutes.
1. While in the CONFIRMATION menu, use AIR to place the cursor next to BEEP
INTERVAL.
2. Press and release POWER MODE. The current setting flashes.
3. Use AIR to display the desired setting.
4. Press and release POWER MODE to save the setting and return to the Confirmation Menu.
5. See “ESCAPE” on page 108 to return to User Mode.
ESCAPE
1. While in the CONFIRMATION menu, use AIR to place the cursor next to ESCAPE.
2. Press and release POWER MODE. The instrument returns to User Mode.
3. See “Returning to Measuring Mode (START MEASURE)” on page 117 to return to
Measuring Mode.
MAINTE 7:49
BEEP SELECT
BEEP INTERVAL
ESCAPE
CONFIRMATION
To Next Page
Loading...
