Robe AT Series User Manual

15
7.2.User setting
There are 3 items which determine the controller's behaviour:Start Val ;S.Blackout ;S.Lock.
Item "Start Val."-determines the slider position at which starts program/record its running.
Value limits:0- bottom position of the slider track
255-upper position of the slider track
Adjusted value is accepted for both sliders INT A and INT B.
Example:
"Start Val." = 128
If the slider INT A (INT B) is halfway of its track,the scene/program/record will start its running .
Item "S.Blackout."(Start Blackout)-determines whether blackout mode is active after switching the controller
on("YES"=STROBE button is on,"NO"= STROBE button is off).
Item "S.Lock."(Start Lock)-determines whether the password is active after switching the controller on ("YES"=the
controller is locked,"NO"= the controller is unlocked after switching the controller on).
To set above mentioned items:
1.Press <ESC> several times until the display shows the initial screen.
2.Press <MENU> and use <UP>,<DOWN> to scroll to the "User setting" menu ("Setup" ==> <ENTER>==>
"User setting"==><ENTER>).The following screen appears:
USER SETTING
Start Val.: 100
S.Blackout: YES
S.Lock: NO
3.Use <UP>,<DOWN> or TILT wheel to adjust desired "Start Val" value (1-255),press <RIGHT>and adjust
desired "S.Blackout" value (YES,NO) with <UP>,<DOWN>, then press <RIGHT> and adjust desired "S.Lock"
value (YES,NO) with <UP>,<DOWN>.
4.Press <ENTER> and the safety question appears:
SAVE CHANGES ?
ESC/ENT
5.Press <ENTER> to save the adjusted values or <ESC> to leave this menu without saving changes.
7.3.Changing the password
The controller operating is protected from unauthorized person by the password,which contains a combination of
any of 4 PROJECTOR SELECT buttons <1>,<2>.....<20>.
The default password is <1>,<2>,<3>,<4>.
To be locked the controller after switching it on,set the Item "S.LOCK." to YES in the "User setting" menu).
During its operation the controller can be locked by pressing the CHANNEL RANGE/LOCK button (the initial
screen has to be displayed).
To change the password:
1.Press <ESC> several times until the display shows the initial screen.
2.Press <MENU> and use <UP>,<DOWN> to scroll to the "Set password" menu ("Setup" ==> <ENTER>==>
"Set password"==><ENTER>).The following screen appears:
SET PASSWORD
Please enter
old password
3.Enter the old password by pressing the matching PROJECTOR SELECT buttons and the new password screen
appears:
SET PASSWORD
Please enter
new password

Robe AT Series Specifications

General

Brand	Robe
Model	AT Series
Category	Controller
Language	English