Robe AT Series - Copying the Projectors Within the Projector Library; Deleting the Projectors from the Projector Library

13
176 - 191 Pulse-effect in sequences with decreasing speed
192 - 223 Random strobe effect with increasing speed
224 - 255 Shutter open
You have to set:
Dimmer range:
Min.:000 Max.:63
Blackout:000 The blackout value may be from the range of 140-159 as well
The dimmer intensity range is important for correct function of the sliders INT A and INT B.The DMX value for
blackout is needed for correct function of the BLACKOUT button.
7. Press <ENTER>.The safety question appears:
SAVE CHANGES ?
ESC/ENT
8.Press <ENTER> to save the new created projector or <ESC> to leave this menu without saving changes.
6.2.Copying the projectors within the projector library
The projectors assigned at positions No.1-50 can be copied only to the projector positions No.51-100.Copying
within the range of positions No.1-50 is not possible.
1.Press <ESC> several times until the display shows the initial screen.
2.Press <MENU> and use <UP>,<DOWN> to scroll to the "Config unit" menu ("Setup" ==> <ENTER>==>
"Config unit"==><ENTER>).The following screen appears:
CONFIG UNIT
Device num: 001 Device order number in the projector library
SPOT 150 XT
3.Use <UP>,<DOWN> to select the free projector position where you want to copy a projector (example: 051).
4.Press <INSERT/COPY>, the following screen appears:
COPY UNIT
From: 001 To: 051 Target position:051
NO DEVICE Copied projector
Use <UP>,<DOWN> to select the projector you want to copy and press <ENTER>.The safety question appears:
SAVE CHANGES ?
ESC/ENT
5.Press <ENTER> to confirm the new projector position or <ESC> to leave this menu without saving changes.
Note: If the target position contains projector,it will be overwritten.
6.3.Deleting the projectors from the projector library
The projectors assigned at positions No.1-50 cannot be deleted.
1.Press <ESC> several times until the display shows the initial screen.
2.Press <MENU> and use <UP>,<DOWN> to scroll to the "Config unit" menu ("Setup" ==> <ENTER>==>
"Config unit"==><ENTER>).The following screen appears:
CONFIG UNIT
Device num: 001 Device order number in the projector library
SPOT 150 XT
3.Use <UP>,<DOWN> to select the desired projector you want to delete (e.g.projector at position 52).
4.Press <DEL>. The safety question appears: