Robe AT Series - Runnig Mode; Running Scenes; Running Programs

33
16.Runnig mode
The following instructions needed to recall and run previously created scanes, programs and records.You can run
2 scenes,programs or records at the same time (RUN A,RUN B buttons).The combinations scene-program,scene-
record or program-record are possible.
15.1.Running scenes
1.Press <ESC> several times until the display shows the initial screen.
2.press <SCENE>.The following screeen appears:
RUN SCENE
Select Scene
Scene num:001 Current scene
USED FREE......scene was not edited (contains data from the scene No.000)
USED......scene was edited
3.Use <UP> , <DOWN> or TILT wheel to select the No. of the scene you wish to run.
4.Check the scene running mask (= projectors which will be used in the scene running) and press the PROJECTOR
SELECT buttons matched to the projectors ,which you don´t want to use in the scene running (their LEDs become
off).
Only those projectors will be active in the scene running where the PROJECTOR SELECT button LEDs shine.
If you wish to run the scene for previously defined group of projectors,press <NEXT/GROUP>,select desired
group (1-20) by pressing the respective PROJECTOR SELECT button.The selected group of projectors can be
expanded/reduced by pressing the respective PROJECTOR SELECT buttons.
5.Press <RUN A> (its LED shines) and the scene is prepared for running.
6.Press <RUN A> again (its LED flashes) and the scene starts running (light intensity can be adjusted with the
help of the slider INT A):
INTENSITY A
Rec.: --- Step:--
Prog.:--- Step:--
Scene: 001 Current running scene
7.Press <RUN A> to stop the scene running.
8.If you want to run 2 scenes at the same time,repeat the instructions 1-6 to start the scene running A .
9.Press <SCENE> to set the scene running B.Repeat the steps 2 -6 for slider INT B.The screen shows:
INT A Rec:--- Scene running A
Prog.:--- Sce.:001 Current scene in the scene running A
INT B Rec: --- Scene running B
Prog.:--- Sce.:002 Current scene in the scene running B
Note :The scene running B "takes" the projectors assigned in the scene running A and vice-versa.
Example:
assigned projectors No. active projectors in scene running
Scene running A 1,2,5,10,15 5,10
Scene running B 1,2,15,16, 1,2,15,16
For correct scene running,the scene running mask should be the same like the mask of the created scene.
10.To stop the scene running A or B, press <RUN A> or <RUN B>.
15.2.Running programs
1.Press <ESC> several times until the display shows the initial screen.
2.press <PROG>,the following screen appears:
RUN PROGRAM
Program num: 001 Selected program No.1
Start step:01 Step from which the selected program will start running
USED Program status: FREE......the program was not edited
USED......the program steps have assigned scenes
3.Use <UP>,<DOWN> or TILT wheel to select No. of the program which you want to run.