22
or "ADJUST" by pressing <UP>,<DOWN> or by rotating the TILT wheel. Active projectors you determine by
pressing matching PROJECTOR SELECT buttons (their LEDs shine).
By pressing <NEXT/GROUP> the current chaser's step is copied to the next step.
Note:
The abbreviation CONCT (constantly) means that the lasting of the chaser step can´t be changed during chaser
running.
The abbreviation ADJUST(adjustable) means that the lasting of the chaser step can be changed during chaser
running.
After editing all chaser's steps,press <ENTER>.The safety question appears:
SAVE CHANGES ?
ESC/ENT
11.Press <ENTER> to save the new chaser or <ESC> to leave this menu without saving changes.
11.4.Copying a chaser
1.Press <ESC> several times until the display shows the initial screen.
2.Press <MENU> and use <UP>,<DOWN> to scroll to the "Make chaser" menu and press <ENTER>.The
following message appears:
MAKE CHASER
Select chaser: 01 Chaser order number
3.Use <UP>,<DOWN> to select the chaser No. (e.g. 20) to which you want to copy another chaser and press
<INSERT/COPY>.The following screen appears:
COPY CHASER
From: 20 To: 20
4.Use <UP>,<DOWN> to select the chaser which you want to copy to previously selected chaser and press
<ENTER>.The safety question appears:
SAVE CHANGES ?
ESC/ENT
5.Press <ENTER> to confirm the copying.
11.5.Running a chaser
The chaser can run during a scene/program/record running or manual controlling of the projectors.The created
chasers (1-20) are assigned to the PROJECTOR SELECT buttons <1>,<2>.....<20>.Please note that all other
functions of the projectors are maintained and that the scenes/programs/records keep running.
1.Press <DEL./CHASER> (its LED starts flashing) and the chaser running screen appears:
RUN CHASER
Speed: +000 Speed for chaser running from -128 to +127,time unit=40 mS
Select chaser Chaser order number
2.Adjust the speed of the chaser running by pressing <UP>,<DOWN> or by rotating TILT wheel .This speed can
be also changed during chaser runnning (chaser running screen has to be displayed).
3.Select desired chaser (1-20) which you vish to run by pressing the matching PROJECTOR SELECT button and
the chaser starts running.To see the previous screen,press <ESC>.
Note:Adjusted chaser speed affects only the chaser's steps with mark "ADJUST".
Examples:
Adjust time:+ 000.....The chaser will run with speed as was determined during its creation
To Next Page
Loading...
Need help?
General
