Robe AT Series - Remote Adjusting the Projectors; Uploading Programs to the Projectors

To Next Page

To Previous Page

8. Remote adjusting the projectors

The controller enables remote adjusting the projectors - projector's display is "transfered" on controller's display

and with <UP>,<DOWN>,<ESC>,<ENTER> you can set desired projector's functions.

The projectors have to be only from ROBE XT-series or AT-series and have master/slave operation. The projectors

should be operated in controller mode (no master/slave mode) to ensure a proper running of this function.

Before using this function, make sure which projectors are connected to DMX output No.1 (use the function

"Rconfig DMX1") and which ones to the DMX output No.2 (use the function "Rconfig DMX2").

1.Press <ESC> until the display shows the initial screen.

2.Press <MENU> and use <UP>,<DOWN> to scroll to the "Rconfig DMX1" menu ("Setup" ==> <ENTER>==>

"Rconfig DMX1" ("Rconfig DMX2")==> <ENTER>).The following screen appears for a moment:

SEARCHING

DEVICES

Wait a minute

************************

In a while the next screen appears (for example):

SELECT DEVICE

Device No.: 01/05 Order number of the found projector /total number of the found projectors

Device ID: FFFF ID (identification number) of the found projector

You need to know the identification codes (ID) for all projectors connected to DMX output No.1(No.2).These

values you will find in projector's menu of the current projectors: A001---->SPEC--->Code.The projectors have to

be from ROBE XT-series or AT-series and have master/slave operation.

3.Use <UP> , <DOWN> to select the desired projector (according to its ID) and press <ENTER>.Next menu

appears:

SELECT FUNCTION

Remote config. Menu for controlling the selected projector

Upload program Menu for uploading programs to the selected projector

4.Use <UP> , <DOWN> to select the "Remote config."menu and press <ENTER>.The following screen appears:

REMOTE CTRL UNIT

Device ID: FFFF ID (identification number) of the projector

Display: A001 projector´s display

Now you can use <UP>,<DOWN>,<ESC>,<ENTER> to control the projector.

5.Press <MENU> to leaves this menu.The displayed projector's menu won't be changed.

9.Uploading programs to the projectors

This function enables copying previously created programs to the projectors.

The projectors have to be only from ROBE XT-series or AT-series and have master/slave operation. The projectors

should be operated in controller mode (no master/slave mode) to ensure a proper behaviour of this function.