Robe AT Series - Presetting a Macro; Running a Macro

23
Adjust time:+001......All steps with mark "ADJUST" will be increased by 40 milliseconds
Adjust time:+127......All steps with mark "ADJUST" will be increased by 5.08 seconds (127x40 mS)
Adjust time:-001......All steps with mark "ADJUST" will be decreased by 40 milliseconds
Adjust time:-128......All steps with mark "ADJUST" will be decreased by 5.12 seconds (128x40 mS)
4.To stop the chaser running ,press <DEL./CHASER> (the chaser running screen has to be displayed).
11.6.Presetting a macro
In macro mode you can preset up to 20 color or gobo values for one ore more projectors.
1.Enter into manual mode by pressing <MAN>.and select desired projector or projectors (e.g. SPOT 160 XT) as
described above in "Manual control of the effects".
2.Press <MACRO>.Its LED flashes and the screen shows:
MACRO MODE
COLOR BANK Bank of colour macros
CH:01-08 Sld:006 Channel range and slider
COLOR Val:001 Matching effect name and its DMX value
3.Select "COLOR" in the effect field:
- by pressing <LEFT>,<RIGHT>
- by rotating the PAN wheel (PAN/TILT button LED has to shine)
- by moving the matching DMX CHANNEL/FUNCTION slider
4.Press the PROJECTOR SELECT button No.1 and adjust desired DMX value for "COLOR":
- by pressing <LEFT>,<RIGHT>
- by rotating the TILT wheel (PAN/TILT button LED has to shine)
- by moving the matching DMX CHANNEL/FUNCTION slider
5.Press <ENTER> to assign the adjusted "COLOR" value to the PROJECTOR SELECT button No.1.
6.Repeat the step 4 and assign next "COLOR" value to the PROJECTOR SELECT button No.2.
In this way assign the desired colours to the buttons No.3-20.
7.Press <MACRO> again.The gobo bank screen appears:
MACRO MODE
GOBO BANK Bank of gobo macros
CH:01-08 Sld:007 Channel range and slider
GOBO Val:001 Matching effect name and its DMX value
8.Select "GOBO" in the effect field:
- by pressing <LEFT>,<RIGHT>
- by rotating the PAN wheel (PAN/TILT button LED has to shine)
- by moving the matching DMX CHANNEL/FUNCTION slider
9.Assign the gobos to the PROJECTOR SELECT buttons No.1-20 as you have done for colours.
10.To save the macro,press <ESCAPE>.The safety question appears:
SAVE CHANGES ?
ESC/ENT
11.Press <ENTER> to save the macro you have made or <ESC> to leave the macro menu without saving
changes.
Note:You can select more than one projectors - in this case the macro will run with all selected projectors.The
projectors should be of the same type.
The macro mode will run correct only with these effect names:"COLOR" and "GOBO".
11.7.Running a macro
1.Enter into manual mode by pressing <MAN>,select projector(s) you wish to use in a macro running.
2.Enter into macro mode by pressing <MACRO> and by pressing PROJECTOR SELECT buttons No.1-20 you
can activate the previously created colour macros.
3.Use <MACRO> to switch between the colour and gobo macros.
Note:Colour/gobo macros are matched to the PROJECTOR SELECT buttons No.1-20.If you change the projector
assigning to the PROJECTOR SELECT buttons,you will have to make new macros.
4.To stop the macro running,press <ESC>.