ROBOTIQ PE20 - Safety; Disclaimer

2.Safety
2.1.Disclaimer
The intent of this section is to provide general guidelines for the safe use of the Robotiq Palletizing Solution.
Alwaysfollow local regulations.
The installer isresponsible for the safe installation and commissioning of the Palletizing Solution.
Robotiq accepts no liability for damage, injury or any legal responsibility incurred directly or indirectly from the use of this product.
The user (installer and operator) shall observe safe and lawful practices including but not limited to those set forth in this
document.
The termsuser, operator and installer, refer to anyone responsible for any of the following operations on the Robotiq Palletizing
Solution:
l
Installation
l
Control
l
Maintenance
l
Inspection
l
Calibration
l
Programming
l
Decommissioning.
The present section is based on the following international standardsand technical specifications:
l
ISO 10218-1:2011 : Safety Requirements For Industrial Robots- Robots
l
ISO 10218-2:2011 : Safety Requirements For Industrial Robots- Robots Systemsand Integrators
l
IEC 60204-1 : Safety Of Machinery - Electrical Equipment Of Machines
l
ISO/TS15066:2016 : Robotsand robotic devices— Collaborative robots
This manual details the componentsof the Robotiq Palletizing Solution, and the general operationsregarding the whole lifecycle
of the product, from installation to operation and decommissioning.
The drawings and photos in this manual are representative examples. However, discrepancies may be observed between the
visual supports and the actual product.
8