Extended Functionalities • 7
143
Patient lists When starting a Patient Test, there will be the option of
either selecting a Patient ID from a patient list, entering
the Patient ID using the onscreen keypad or, if available,
of scanning the barcode with the Patient ID. The Patient
ID, if entered on the DMS, comes with an additional iden-
tification entry. Up to 20 characters can be used and
assigned as a second confirmation (e.g., name, date of
birth).
There are four possible configurations for a Patient ID
input:
■ The Patient ID is set to Optional or Required, and
there is no list available:
A Patient ID can be entered manually via the
onscreen keypad or read in via a barcode scan. The
Patient ID is stored with the test result.
■ The Patient ID is set to No, but there is a list
available:
The list of Patient IDs is always shown when
starting a test. You may now
– select a patient from the list;
– scan a Patient ID using the barcode scanner;
– create a new patient entry by touching New.
Instead of an ID a consecutive number will be
assigned to this result.
To Next Page
Loading...
