172
Using the OTS function A request for an Observed Test Sequence comes from the
DMS. The presence of the icon on the Patient Test
button indicates a pending OTS request.
Observer:
1 Touch Patient Test.
In the Pat. Test -OTS menu, the Patient Test button is
grayed out (disabled) until the observer has logged in.
2 Touch Observer Login.
3 Wait until the observer list is displayed.
4 Select your observer ID by touching the corre-
sponding button, or scan your operator ID (which is
also your observer ID in this case).
5 Enter the (optional) password.
6 After you enter your password, touch to log in.
The Pat. Test - OTS menu is displayed again. The
Patient Test button is now active.
7 Hand the meter to the operator who can now per-
form the patient test under supervision.
Observer
09:15 am
05/29/2015
Ann Casey
Alan Smithee
Scan
Pat. Test - OTS
09:15 am
05/29/2015
Observer Login
Patient T
est
OTS enabled
Main Menu
09:15 am
05/29/2015
Control Test
Review Results
Setup
Patient T
est
Logout
Pat. Test - OTS
09:15 am
05/29/2015
Observer Login
Patient T
est
OTS enabled
Only operators with OTS observer rights are listed in the
Observer Login list.
To Next Page
Loading...
