Meter Setup • 3
67
Computer The CoaguChek Pro II meter can connect with a compu-
ter or host system running appropriate software (that is, a
DMS must be installed). To use this connectivity feature,
however, you need the optional Handheld Base Unit or
the meter must be configured for wireless communica-
tion. If no wireless communication is configured, the
connection is established in two steps.
■ The meter connects to the Handheld Base Unit via
infrared.
■ The Handheld Base Unit is either connected to a
single computer (via USB) or to a network/host
system (via ethernet).
The option Computer (when activated) can be used
together with a DMS to set up:
■ operator lists, or
■ patient lists (lists of patients to be tested)
This eliminates the need for manual entry of these data.
In addition, you can transfer test results stored in the
meter to other systems for archiving or further evaluation.
The option Computer controls the meter’s ability to com-
municate with a computer or a network.
13 Touch Computer. Your selection is now
highlighted.
14 Touch to save this setting, or touch to exit
this menu without saving any changes. The display
automatically returns to the previous screen.
Extended data handling functionality is dependent on
the capabilities of the particular Data Management
System (DMS) being used and may vary.
Connection
09:15 am
05/29/2015
Printer
Computer
Off
QR Code
To Next Page
Loading...
