Putting the Meter into Operation • 2
37
Removing the battery pack 1 If a battery pack is already installed, make sure that
the meter is powered off.
2 Place the meter face down on a level surface.
3 Using a an appropriate starshaped screwdriver, e.g.
Torx
®
size T5, remove the four screws holding the
battery compartment cover in place.
4 Remove the battery compartment cover from the
meter. The battery pack now visible is connected to
the meter by a plug.
5 Carefully lift the battery pack and remove the plug
connector.
Disposal of used battery packs
Do not dispose of the battery pack with normal domestic
waste. Dispose of used battery packs in accordance with
applicable local regulations and directives and your
facility’s guidelines on the disposal of electronic waste
equipment.
To Next Page
Loading...
