Roche CoaguCheck Pro II - Parameter Selection

Meter Setup • 3
69
Parameter Selection When performing a test, the meter can be set to display a
screen that allows the operator to select the test parame-
ter to be used. Otherwise the meter will determine the
test parameter by reading the test strip (barcode) infor-
mation from the inserted test strip.
1 From the Main Menu, touch Setup to open the
meter settings.
2 From the Setup Menu, touch Options.
3 From the Options menu, touch Parameter
Selection.
4 Touch Enable to display the parameter selection
screen prior to each test or touch Disable to have
the meter select the parameter by reading the test
strip information.
5 Touch to save this setting, or touch to exit
this menu without saving any changes.
Options
09:15 am
05/29/2015
Auto Off
Connection
Beeper
Sor
t
Parameter Selection
Setup Menu
09:15 am
05/29/2015
QC Settings
ID Setup
Diagnostics
Options
Screen
Main Menu
09:15 am
05/29/2015
Control Test
Review Results
Setup
Patient T
est
Select Param.
09:15 am
05/29/2015
Enable
Disable