Testing a Blood Sample • 4
99
Powering on the meter
1 Place the meter on a level, vibration-free surface, or
hold it in your hand so it is roughly horizontal.
2 Power the meter on by pressing .
The next steps depend on whether you work with the
function Operator ID set to inactive or active (see “Data
handling” on page 139).
If the function Operator ID is inactive:
3 Wait until the Main Menu is displayed.
You can also power on the meter directly by inserting a
test strip or connecting the power adapter.
Main Menu
09:15 am
05/29/2015
Control Test
Review Results
Setup
Patient T
est
To Next Page
Loading...
