100
If the function Operator ID is active:
Without operator list:
3 You are now prompted to enter an Operator ID
1
.
■ Enter the Operator ID using the keypad. Touch
to move to the next screen.
■ Alternatively, the Operator ID can also be entered
using the built-in barcode scanner
2
. Touch
Scan and scan the operator barcode from a dis-
tance of approx. 10-20 cm (4-8 inches), according
to the barcode size. The meter beeps once the bar-
code has been read successfully. The barcode
information appears in the operator ID field. The
scanner turns off after 10 seconds, if a barcode is
not scanned.
1. For configuring operator and patient IDs, see page 145.
Operator ID
A
|
BCDE
FGHI J
KLMNO
PQRST
UVWXY
Z 123
09:15 am
,
Scan
2. A list of supported barcode symbologies can be found in
Appendix A.2 on page 166, a list of supported characters
in Appendix A.3 on page 169.
To Next Page
Loading...
