3.11
Press F3
Reflotron Plus displays the first parameter to be entered.
Use a decimal point when entering decimals.
Every entry has to be terminated by pressing “enter”. Certain limits
have to be observed.
The next parameters asked for are “TG” and “HDL”.
If a value entered is above or below the limits programmed into the
instrument Reflotron Plus indicates this by placing the sign “<” or “>”
before the respective maximum or minimum value and performs the
calculation using the programmed limit value.
Maximum and minimum values programmed into the instrument:
minimum maximum
Cholesterol mg/dl: 100 999.99
mmol/l: 2.586 25.86
Triglycerides mg/dl: 1.0 400.0
mmol/l: 0.011 4.572
HDL cholesterol mg/dl: 25.0 75.0
mmol/l: 0.647 1.940
The following functions can be performed now:
– Searching and copying
– Changing existing values
– Printout of a record
– Export of a record
R See also “Calculation of cardiac risk according to PROCAM” in this
Section.
Press the “Escape” key to return to analysis mode.
Calling up the function
LD L A C C . T O F R I EDE W A L D
CH O L m g / d l ?
LD L A C C . T O F R I EDE W A L D
LD L 1 0 5 .0 0 m g / dl
Exiting the function
To Next Page
Loading...