Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Page 183

Rockwell Automation Publication D2-3518-4 - January 2020 183
Parameter Descriptions Chapter 9
This parameter is for service use only.
This parameter is for service use only.
This parameter is for service use only.
Enables/disables annunciation of the faults shown in Figure 76
.
Figure 76 - Fault Config (238)
235
Testpoint 1 Data
Range: -/+ 217483646
Default: 0
Access: 0 Path: Utility > Diagnostics
See also:
236
Testpoint 2 Sel
Range: 0...65535
Default: 499
Access: 0 Path: Utility > Diagnostics
See also:
237
Testpoint 2 Data
Range: -/+ 217483646
Default: 0
Access: 0 Path: Utility > Diagnostics
See also:
238
Fault Config
Range: See Figure 76
Default: See Figure 76
Access: 0 Path: Utility > Fault Queue
See also:
0
xx
x
x
x
x
x
xxx
x
xxxx
0011234567891112131415
1 =Enabled
0=Disabled
x =Reserved
Bit #
Factory Default Bit Values
Carrier Sync Loss
Nibble 1Nibble 2Nibble 3Nibble 4