Rockwell Automation Allen-Bradley LiquiFlo 2.0 - Page 82

82 Rockwell Automation Publication D2-3518-4 - January 2020
Chapter 9 Parameter Descriptions
Sets the highest RMS voltage the drive will output. See description of rectifier
Max Motor Volts parameter (107 in rectifiers parameters).
Sets the maximum allowable frequency the drive will output. Note that this is not
maximum speed, which is set in parameter 82. See Figure 36
.
See description of rectifier Max Motor Freq parameter (108 in rectifiers
parameters).
Figure 36 - Speed Limits
Enables/disables the compensation correction options.
Figure 37 - Compensation (56)
55
Maximum Freq
Range: 5.0...250.0 Hz [0.1 Hz]
Default: 130.0 Hz
Access: 0 Path: Motor Control > Torq Attributes
See also: 82, 83, rectifier 108
56
Compensation
Range: See Figure 37
Default: See Figure 37
Access: 1 Path: Motor Control > Torq Attributes
See also:
Allowable Output Frequency Range
Bus Regulation or Current Limit
V
o
l
t
a
g
e
Frequency
Allowable Output Frequency Range
Normal Operation
Allowable Reference Frequency Range
Frequency Trim due to
Speed Control Mode
Max Volts
Motor Volts
Break Volts
Start Boost
Run
0 Min
Speed
Motor
Hz
Max
Speed
Output
Freq Limit
Max
Freq
Break
Frequency
Overspeed
Limit
1000xxxxxxxxxxxx
0011234567891112131415
1 =Enabled
0=Disabled
x =Reserved
Bit #
Factory Default Bit Values
Reflect Wave
Enable Jerk
Ixo AutoCalc
Extended Range
Nibble 1Nibble 2Nibble 3Nibble 4