Remote Control Commands
R&S
®
NRPxxA(N)
101User Manual 1177.6017.02 ─ 05
Global Flags................................................................................................................102
└ S-Parameter Correction ON by Default........................................................ 102
└ S-Parameter Correction State Locked..........................................................102
└ S-Parameter Device Locked.........................................................................103
└ Use Flags in Factory Cal. Data Set...............................................................103
Device table................................................................................................................ 103
Menu bar
Contains the following submenus.
File ← Menu bar
Provides options for loading and saving calibration data files, see:
●
"To change the S-parameter data" on page 105
●
"To load an uncertainty parameter file" on page 106
Sensor ← Menu bar
Provides options for loading and saving calibration data directly from or to the sensor,
see:
●
"To load a calibration data set from a power sensor" on page 104
●
"To save the calibration data to the sensor" on page 107
Device ← Menu bar
Provides functions for editing the table of S-parameter devices.
Options ← Menu bar
Provides functions for editing user data, changing remote control timeouts, and dis-
playing calibration data as plain text.
User Data ← Options ← Menu bar
Opens the "User Data" dialog.
Here, you can enter the name of the calibration laboratory and the calibration engineer
that is stored in the calibration data set if changes are made.
Remote ← Options ← Menu bar
Opens the "Remote Control Settings" dialog. It is normally not necessary to change
timeouts.
Configuring Basic Measurement Parameters
To Next Page
Loading...
