Operating Concepts
R&S
®
NRPxxA(N)
34User Manual 1177.6017.02 ─ 05
The main dialog of the web user interface opens.
4. Select the "Continuous Average" tab and perform any necessary changes.
5. Press "Measurement > ON" to start the measurement.
For a detailed description of the web user interface, refer to Chapter 6, "Browser-
Based User Interface", on page 43.
5.3 Remote Control
You can remote control the R&S NRPxxA(N) easily. The change to remote control
occurs "on the fly" and has no influence on the manual operation.
Further information:
●
Chapter 9, "Remote Control Commands", on page 63
●
Chapter 11, "Remote Control Basics", on page 133
●
Chapter 11.1, "Remote Control Interfaces and Protocols", on page 133
●
Chapter 3.5, "Connecting to a Computer", on page 15
5.4 R&S NRPV
The R&S NRPV enables you to measure power in all available measurement modes.
Also, you can use up to four power sensors simultaneously.
The R&S NRPV is provided on your documentation CD-ROM and on the Rohde &
Schwarz website as a separate standalone installation package.
R&S NRPV
To Next Page
Loading...
