Rohde & Schwarz NRPxxA Series - Using the S-Parameters Tool

Remote Control Commands
R&S
®
NRPxxA(N)
100User Manual 1177.6017.02 ─ 05
9.8.3.5 Using the S-Parameters Tool
The S-Parameters tool helps loading an S-parameter table into the power sensor. The
S-Parameters tool is part of the R&S NRP Toolkit, see Chapter 5.1, "R&S NRP Toolkit",
on page 29.
To start the S-Parameters tool
► In the Windows start menu, select "NRP Toolkit" > "S-Parameter Update Multi".
User Interface of the S-Parameters Tool
Figure 9-5: S-Parameters dialog
Menu bar.....................................................................................................................101
└ File................................................................................................................ 101
└ Sensor...........................................................................................................101
└ Device...........................................................................................................101
└ Options..........................................................................................................101
└ User Data............................................................................................101
└ Remote............................................................................................... 101
└ Show Cal. Data...................................................................................102
Configuring Basic Measurement Parameters