Rohde & Schwarz NRPxxA Series - Setting up a LAN Connection; Connecting a LAN Power Sensor and a Computer

Preparing for Use
R&S
®
NRPxxA(N)
18User Manual 1177.6017.02 ─ 05
b) Connect the power sensors to the R&S NRP‑Z5 sensor hub. You can connect
up to four sensors.
c) Connect the R&S NRP‑Z5 to the computer.
d) Connect the power sensors to the signal source.
e) Connect the delivered external power supply unit to the R&S NRP‑Z5 and to an
AC supply connector.
f) Connect the trigger input of the R&S NRP‑Z5 with a BNC cable to the trigger
source (optional).
g) Connect the trigger output of the R&S NRP‑Z5 with a BNC cable to the trigger
device (optional).
2. On the computer, start a software application to view the measurement results.
See Chapter 5, "Operating Concepts", on page 29.
3.5.2 Setting Up a LAN Connection
Requires power sensors with networking capabilities, the R&S NRP LAN power sen-
sors.
This section describes how to connect the sensor to a LAN network and configure the
LAN interface for establishing a connection.
Electromagnetic interference (EMI) can affect the measurement results. To avoid any
impact, use category 5 cables or better.
3.5.2.1 Connecting a LAN Power Sensor and a Computer
There are different ways to connect a LAN power sensor to a computer according to
the available equipment:
Connecting to a Computer