Rohde & Schwarz NRPxxA Series - Averaging; Continuous Average Mode; Measurement Modes; S-Parameter

Browser-Based User Interface
R&S
®
NRPxxA(N)
46User Manual 1177.6017.02 ─ 05
<State> ← Offset
Enables or disables the usage of the level offset.
Remote command:
[SENSe<Sensor>:]CORRection:OFFSet:STATe on page 96
<Value> ← Offset
Adds a fixed level offset in dB to account for external losses.
Remote command:
[SENSe<Sensor>:]CORRection:OFFSet on page 95
S-Parameter
Selects the mode used for the S-parameters. S-parameters are used to compensate
for a component (attenuator, directional coupler) connected ahead of the sensor.
Averaging
See "Averaging Mode" on page 50.
6.4 Measurement Modes
Describes the parameters for the available measurement modes.
● Continuous Average Mode......................................................................................46
6.4.1 Continuous Average Mode
Describes the parameters of the continuous average measurement.
Further information:
●
Chapter 9.7.1, "Continuous Average Measurement", on page 87
Detailed description of the continuous average mode and its remote commands
Access: main dialog of the web user interface > navigation pane > "Continuous Aver-
age"
Aperture Time................................................................................................................46
Duty Cycle.....................................................................................................................47
Smoothing.....................................................................................................................47
Aperture Time
Sets the aperture time, the width of the sampling windows.
Measurement Modes