Rohde & Schwarz NRPxxA Series - Operation Measuring Status Register; Operation Trigger Status Register

Remote Control Basics
R&S
®
NRPxxA(N)
154User Manual 1177.6017.02 ─ 05
Table 11-11: Meaning of bits used in the operation calibrating status register
Bit No. Meaning
0 Not used
1 Sensor calibrating
The sensor is being calibrated
5 to 15 Not used
11.3.8.2 Operation Measuring Status Register
The CONDition register contains information about whether a measurement is being
performed by a sensor and, depending on the configuration of the transition register.
The EVENt register indicates whether a measurement was started or completed since
the last readout of this register.
Querying the register:
●
STATus:OPERation:MEASuring:CONDition?
●
STATus:OPERation:MEASuring[:SUMMary][:EVENt]?
Table 11-12: Meaning of bits used in the operation measuring status register
Bit No. Meaning
0 Not used
1 Sensor measuring
The sensor is performing a measurement.
5 to 15 Not used
11.3.8.3 Operation Trigger Status Register
The CONDition register contains information about whether a sensor is in the waiting
for trigger state, i.e. expecting a trigger event and, depending on the configuration of
the transition register. TheEVENt register indicates whether the waiting for trigger state
was entered or quit by a sensor since the last readout of the register.
Querying the register:
●
STATus:OPERation:TRIGger:CONDition?
●
STATus:OPERation:TRIGger[:SUMMary][:EVENt]?
Table 11-13: Meaning of bits used in the operation trigger status register
Bit No. Meaning
0 Not used
1 Sensor waiting for trigger
The sensor is in the waiting for trigger state and is waiting for a trigger event. When the
trigger event occurs, the sensor changes into the measuring state.
5 to 15 Not used
Status Reporting System