Rohde & Schwarz NRPxxA Series - Using the Status Register; General Status Register Commands

Remote Control Commands
R&S
®
NRPxxA(N)
124User Manual 1177.6017.02 ─ 05
Results in a display as shown in Figure 9-7.
Figure 9-7: Sensor Name
Parameters:
<sensorname>
Manual operation: See "Sensor Name" on page 54
SYSTem:VERSion?
Queries the SCPI version that the command set of the sensor complies with.
Example:
SYST:VERS?
Query
1999.0
Response: SCPI version from 1999.
Usage: Query only
9.12 Using the Status Register
Further information:
●
Chapter 11.3, "Status Reporting System", on page 143
Contents:
● General Status Register Commands.................................................................... 124
● Reading Out the CONDition Part.......................................................................... 125
● Reading Out the EVENt Part.................................................................................125
● Controlling the ENABle Part..................................................................................126
● Controlling the Negative Transition Part............................................................... 126
● Controlling the Positive Transition Part................................................................. 127
9.12.1 General Status Register Commands
STATus:PRESet.............................................................................................................125
STATus:QUEue[:NEXT]?................................................................................................ 125
Using the Status Register