Rohde & Schwarz NRPxxA Series - Reading out the Condition Part; Reading out the Event Part

Remote Control Commands
R&S
®
NRPxxA(N)
125User Manual 1177.6017.02 ─ 05
STATus:PRESet
Resets the edge detectors and ENABle parts of all registers to a defined value.
Usage: Event
STATus:QUEue[:NEXT]?
Queries the most recent error queue entry and deletes it.
Positive error numbers indicate sensor specific errors. Negative error numbers are
error messages defined by SCPI.
If the error queue is empty, the error number 0, "No error", is returned.
Usage:
Query only
9.12.2
Reading Out the CONDition Part
Further information:
●
Chapter 11.3.2, "Structure of a SCPI Status Register", on page 144
STATus:DEVice:CONDition?
STATus:OPERation:CALibrating:CONDition?
STATus:OPERation:CONDition?
STATus:OPERation:LLFail:CONDition?
STATus:OPERation:MEASuring:CONDition?
STATus:OPERation:SENSe:CONDition?
STATus:OPERation:TRIGger:CONDition?
STATus:OPERation:ULFail:CONDition?
STATus:QUEStionable:CALibration:CONDition?
STATus:QUEStionable:CONDition?
STATus:QUEStionable:POWer:CONDition?
STATus:QUEStionable:WINDow:CONDition?
Usage:
Query only
9.12.3 Reading Out the EVENt Part
Further information:
●
Chapter 11.3.2, "Structure of a SCPI Status Register", on page 144
STATus:DEVice[:EVENt]?
STATus:OPERation:CALibrating[:SUMMary][:EVENt]?
STATus:OPERation[:EVENt]?
STATus:OPERation:LLFail[:SUMMary][:EVENt]?
STATus:OPERation:MEASuring[:SUMMary][:EVENt]?
STATus:OPERation:SENSe[:SUMMary][:EVENt]?
STATus:OPERation:TRIGger[:SUMMary][:EVENt]?
STATus:OPERation:ULFail[:SUMMary][:EVENt]?
Using the Status Register