Rohde & Schwarz NRPxxA Series - Page 6

Contents
R&S
®
NRPxxA(N)
6User Manual 1177.6017.02 ─ 05
9.8.2 Setting the Frequency................................................................................................... 94
9.8.3 Configuring Corrections................................................................................................ 94
9.8.3.1 Duty Cycle Corrections................................................................................................. 94
9.8.3.2 Offset Corrections......................................................................................................... 95
9.8.3.3 S-Parameter Correction................................................................................................ 96
9.8.3.4 S-Gamma Corrections.................................................................................................. 98
9.8.3.5 Using the S-Parameters Tool...................................................................................... 100
9.9 Calibrating/Zeroing the Power Sensor ...................................................................109
9.10 Testing the Power Sensor.........................................................................................111
9.11 Configuring the System............................................................................................112
9.12 Using the Status Register........................................................................................ 124
9.12.1 General Status Register Commands.......................................................................... 124
9.12.2 Reading Out the CONDition Part................................................................................ 125
9.12.3 Reading Out the EVENt Part.......................................................................................125
9.12.4 Controlling the ENABle Part........................................................................................126
9.12.5 Controlling the Negative Transition Part......................................................................126
9.12.6 Controlling the Positive Transition Part....................................................................... 127
10 Performing Measurement Tasks - Programming Examples.......... 128
10.1 Performing the Simplest Measurement.................................................................. 128
10.2 Performing the Fastest Measurement in Continuous Average Mode.................. 128
10.3 Performing a Buffered Continuous Average Measurement.................................. 130
11 Remote Control Basics......................................................................133
11.1 Remote Control Interfaces and Protocols.............................................................. 133
11.1.1 USB Interface..............................................................................................................133
11.1.2 Ethernet Interface........................................................................................................134
11.1.2.1 VISA Resource Strings............................................................................................... 134
11.1.2.2 VXI-11 Protocol........................................................................................................... 136
11.1.2.3 HiSLIP Protocol...........................................................................................................136
11.1.2.4 Socket Communication............................................................................................... 137
11.2 SCPI Command Structure........................................................................................ 137
11.2.1 Syntax for Common Commands................................................................................. 137
11.2.2 Syntax for Device-Specific Commands.......................................................................138
11.2.3 SCPI Parameters........................................................................................................ 139