Rohde & Schwarz SMA100B - Source > Noise Generator Settings

Analog Modulations
R&S
®
SMA100B
103User Manual 1178.3834.02 ─ 05
Bandwidth
Displays the maximum bandwidth of the external LF signal.
Remote command:
[:SOURce]:LFOutput<ch>:BANDwidth? on page 602
Show Connector
Accesses a dialog that displays the physical location of the selected connector on the
front/rear panel of the instrument.
4.4.6.3 Source > Noise Generator Settings
Access:
► Select "Modulation" > "Modulation Sources > Noise Generator".
The "Noise Generator" settings contain all parameters to configure the signal of the
internal noise generator.
Settings
Distribution.................................................................................................................. 103
Bandwidth................................................................................................................... 103
Distribution
Selects the distribution of the noise power density.
"Gauss"
Generates the noise power according to a Gaussian distribution.
"Equal"
Generates an evenly distributed noise.
Remote command:
[:SOURce<hw>]:NOISe:DISTribution on page 626
Bandwidth
Sets the noise bandwidth as distinct value.
You can set the bandwidth between 100 kHz and 10 MHz in 100 KHz steps.
Modulation Settings