Rohde & Schwarz SMA100B - Clock Synthesizer Connectors; Rear Panel Tour; LF Modulation Connectors

Getting Started
R&S
®
SMA100B
39User Manual 1178.3834.02 ─ 05
Pulse Video
Output of the internal pulse generator signal or the looped through pulse signal from
Pulse Ext connector (video signal).
See Chapter 4.4.1, "Pulse Modulation", on page 76.
Pulse Ext
Input for an external pulse modulation signal or an external trigger/gate signal for the
pulse generator.
2.2.1.13 LF Modulation Connectors
LF
Output for internal LF generator signal.
See also data sheet and user manual, section "Analog Modulation".
Ext
Input for external analog modulation signals.
See Chapter 4, "Analog Modulations", on page 73.
2.2.1.14 Clock Synthesizer Connectors
Clk Syn/Clk Syn N
Connectors for output of the clock synthesizer signal, or the inverted signal.
2.2.2 Rear Panel Tour
This section provides an overview of the connectors at the rear panel of the instrument.
For technical data of the connectors, refer to the data sheet.
Figure 2-4: Rear panel view of the R&S
SMA100B RF Signal Generator with height unit 2HU (option
R&S SMAB-B92)
1 = IEC 625/IEEE 488 connector
2 = USB In connector (type micro-B)
3 = LAN connector
4 = USB connector (type A)
5 = V/GHz X-Axis and Z-Axis output connectors (BNC)
6 = Stop input and output connector (BNC)
7 = Marker User1 output connector (BNC)
Instrument Tour