Improving Level Performance
R&S
®
SMA100B
238User Manual 1178.3834.02 ─ 05
State - Gate
Enables time gated measurement. The measurement is started with the "Start" button
in the main measurement diagram. Both gates are active at one time.
The gate borders and the measurement values (average and peak power) are indica-
ted in/below the measurement diagram. The indication is only available for certain dia-
gram views which are switched with the "Rearrange" key.
Remote command:
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STATe on page 452
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:AVERage? on page 451
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:MAXimum? on page 451
:TRACe[:POWer]:SWEep:MEASurement:GATE:DISPlay:ANNotation[:STATe]
on page 496
Start / Stop - Gate
Sets the start and the stop times for the respective gate.
Remote command:
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STARt on page 452
:CALCulate[:POWer]:SWEep:TIME:GATE<ch>:STOP on page 452
Configure Sensors
Access:
1. Select "Clk Syn/Power Sens" > "NRP Power Analysis".
2. Select "Configure" > "Configure Sensors"
Using Power Sensors
To Next Page
Loading...
