Rohde & Schwarz SMA100B - List Mode File Operation

Remote Control Commands
R&S
®
SMA100B
620User Manual 1178.3834.02 ─ 05
AUTO|IMMediate
The trigger is free-running, i.e. the trigger condition is fulfilled
continuously. The selected list is restarted as soon as it is fin-
ished.
SINGle|BUS
The list is triggered by the command [:SOURce<hw>]:LIST:
TRIGger:EXECute. The list is executed once.
EXTernal
The list is triggered externally and executed once.
*RST: AUTO
Example: See Example "Create an RF list and activate the list mode"
on page 612.
Manual operation: See "Mode" on page 184
[:SOURce<hw>]:LIST:RUNNing?
Queries the current state of the list mode.
Return values:
<State> 0 | 1 | OFF | ON
1
Signal generation based on the list mode is active.
Example: See Example "Create an RF list and activate the list mode"
on page 612.
Usage: Query only
13.16.7.2 List Mode File Operation
The following section covers basic commands to file handling in list mode.
[:SOURce<hw>]:LIST:CATalog?.......................................................................................620
[:SOURce<hw>]:LIST:DELete..........................................................................................621
[:SOURce<hw>]:LIST:DELete:ALL................................................................................... 621
[:SOURce<hw>]:LIST:FREE?.......................................................................................... 621
[:SOURce<hw>]:LIST:RESet........................................................................................... 622
[:SOURce<hw>]:LIST:SELect.......................................................................................... 622
[:SOURce<hw>]:LIST:CATalog?
Queries the available list files in the specified directory.
Return values:
<Catalog> string
List of list filenames, separated by commas
Example: See Example "Create an RF list and activate the list mode"
on page 612.
SOURce Subsystem