Rohde & Schwarz SMA100B - RF Phase Settings; Readjust; User Variation

RF Signal Configuration
R&S
®
SMA100B
71User Manual 1178.3834.02 ─ 05
Remote command:
[:SOURce<hw>]:POWer:RANGe:LOWer? on page 636
[:SOURce<hw>]:POWer:RANGe:UPPer? on page 636
Readjust
Recalculates and adjusts the internal switch positions of the RF chain according to the
current level.
Remote command:
[:SOURce<hw>]:POWer:ALC:SONCe on page 630
User Variation
Defines and activates a user-defined step width for varying the RF frequency or RF
level with the rotary knob.
If disabled, the step width varies in steps of one unit at the cursor position.
Variation Active ← User Variation
Activates the set user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP:MODE on page 596
[:SOURce<hw>]:POWer:STEP:MODE on page 634
Variation Step ← User Variation
Sets the user-defined step width.
Remote command:
[:SOURce<hw>]:FREQuency:STEP[:INCRement] on page 596
[:SOURce<hw>]:POWer:STEP[:INCRement] on page 634
3.5 RF Phase Settings
The phase in sinusoidal signals defines the initial angle at its origin.
Access:
1. Select "Frequency" > "Phase".
In the "Phase" tab, you can determine the delta phase value and reset the phase to
this reference.
RF Phase Settings