Rohde & Schwarz SMA100B - LF Generator Settings

Remote Control Commands
R&S
®
SMA100B
601User Manual 1178.3834.02 ─ 05
SOURce1:LFOutput1:SHAPe:PULSe:WIDTh 0.0005
SOURce1:LFOutput1:SHAPe:PULSe:DCYCle 0.5
// configure the signal of the LF1 generator
SOURce1:LFOutput2:SHAPe SINE
SOURce1:LFOutput2:FREQuency 1000000
SOURce1:LFOutput2:PERiod?
// 0.000001
// changing the LF signal shape
// SOURce1:LFOutput2:SHAPe TRAP
// SOURce1:LFOutput2:SHAPe:PULSe:PERiod 0.2
// SOURce1:LFOutput2:SHAPe:TRAPeze:RISE 0.0001
// SOURce1:LFOutput2:SHAPe:TRAPeze:FALL 0.001
// SOURce1:LFOutput2:SHAPe:TRAPeze:FALL 0.0001
// SOURce1:LFOutput2:SHAPe:TRAPeze:HIGH 0.0005
// SOURce1:LFOutput2:SHAPe TRI
// SOURce1:LFOutput2:SHAPe:PULSe:PERiod 0.1
// SOURce1:LFOutput2:SHAPe:TRIangle:RISE 0.0001
// activate the LF output and select the LF1 as signal source
// configure the LF output signal
SOURce1:LFOutput1:FREQuency:MODE CW
SOURce1:LFOutput1:STATe 1
SOURce1:LFOutput1:SOURce LF1
SOURce1:LFOutput1:INTernal:VOLTage 1
SOURce1:LFOutput1:OFFSet 0.001
● LF Generator Settings...........................................................................................601
● LF Sweep Settings................................................................................................609
13.16.6.1 LF Generator Settings
With the commands described in this section, you can configure the LF signal source.
[:SOURce]:LFOutput<ch>:BANDwidth?............................................................................602
[:SOURce]:LFOutput<ch>:FREQuency.............................................................................602
[:SOURce<hw>]:LFOutput<ch>:PERiod?..........................................................................602
[:SOURce<hw>]:LFOutput:FREQuency:MANual............................................................... 603
[:SOURce<hw>]:LFOutput:FREQuency:MODE................................................................. 603
[:SOURce<hw>]:LFOutput:FREQuency:STOP.................................................................. 604
[:SOURce<hw>]:LFOutput:FREQuency:STARt..................................................................604
[:SOURce]:LFOutput<ch>[:STATe]................................................................................... 604
[:SOURce]:LFOutput<ch>:INTernal:VOLTage....................................................................604
[:SOURce]:LFOutput:OFFSet.......................................................................................... 605
[:SOURce]:LFOutput<ch>:SOURce................................................................................. 605
[:SOURce]:LFOutput<ch>:SOURce:PATH........................................................................ 605
[:SOURce]:LFOutput:VOLTage........................................................................................ 606
[:SOURce<hw>]:LFOutput<ch>:SHAPe............................................................................606
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:DCYCle....................................................606
[:SOURce<hw>]:LFOutput<ch>:SHAPe:PULSe:PERiod.....................................................606
SOURce Subsystem