Rohde & Schwarz SMA100B - General Settings

Avionic Standards
R&S
®
SMA100B
144User Manual 1178.3834.02 ─ 05
Settings
● General Settings................................................................................................... 144
● Signal Settings...................................................................................................... 145
● COM/ID Settings................................................................................................... 146
5.4.4.1 General Settings
Access:
1. Select "ILS Component > Marker Beacons", see Chapter 5.4.4, "ILS Marker Bea-
cons Settings", on page 143.
2. Select "ILS > General".
This dialog comprises carrier frequency and signal settings related to the ILS
marker beacons component of the ILS signal.
Settings
Carrier Frequency Mode............................................................................................. 144
Carrier Frequency....................................................................................................... 144
Carrier Frequency Mode
Sets the mode for the carrier frequency of the signal.
"User Defined"
Activates user-defined variation of the carrier frequency.
"Predefined"
Activates variation of the carrier frequency by integer 25 kHz steps.
Remote command:
[:SOURce<hw>][:ILS]:MBEacon:FREQuency:MODE on page 572
Carrier Frequency
Requires "Carrier Frequency Mode > User Defined".
Sets the carrier frequency of the signal.
ILS Configuration and Settings