Rohde & Schwarz SMA100B - Configure Measurement

Improving Level Performance
R&S
®
SMA100B
231User Manual 1178.3834.02 ─ 05
Configure Measurement
Access:
1. Select "Clk Syn/Power Sens" > "NRP Power Analysis".
2. Select "Configure" > "Configure Measurement".
The measurement section provides the parameters for configuring the measurement
either in frequency, power or time domain.
Mode - Power Analysis
Selects the measurement mode.
"Frequency"
Power versus frequency measurement (frequency response).
"Power"
Power versus power measurement (power sweep, AM/AM).
"Time"
Power versus time measurement (envelope power measurement as a
function of time, NRP trace mode). The R&S SMA100B samples
power over a time interval and assigns the internal power values that
have been determined to several points.
This mode also provides gated measurement and pulse data analy-
sis, e.g. with a connected R&S NRP-Z81, and the corresponding
graphical display "Gate View" and "Pulse Data View".
Remote command:
:SENSe[:POWer]:SWEep:MODE on page 478
Min - Power Analysis
Sets the minimum frequency/power/time of the measurement.
Using Power Sensors