Rohde & Schwarz SMA100B - Preset, Set to Default and Factory Preset Settings

File and Data Management
R&S
®
SMA100B
287User Manual 1178.3834.02 ─ 05
Presetting the instrument to a user-defined instrument state
The reset functions set the parameters and operating modes to default values prede-
fined by the factory. Alternatively to these default settings, you can:
●
Define user-specific recall settings to be restored after a preset
(see Chapter 10.2.3, "How to Recall User Settings Automatically after Preset",
on page 288)
●
Store and reload user-defined instrument states
(see Chapter 10.4.2, "How to Save and Recall Instrument Settings", on page 294)
Mark / Do not mark parameters changed from preset
To survey the current state of the settings concerning default values, the
R&S SMA100B offers a feature that visually identifies deviations from the default val-
ues.
For more information, see Chapter 10.2.2, "How to Identify Parameters Which Are Not
in a Preset State", on page 288.
10.2.1 Preset, Set to Default and Factory Preset Settings
Preset..........................................................................................................................287
Set To Default..............................................................................................................287
Preset this Parameter................................................................................................. 287
Execute Factory Preset...............................................................................................287
Preset
Resets all parameters and switching states, and closes all opened dialogs.
Consider also the following possibilities:
●
You can define the settings that are restored when you preset the instrument
(see Chapter 10.2.3, "How to Recall User Settings Automatically after Preset",
on page 288)
●
You can reset the instrument to the factory state
(see "Execute Factory Preset" on page 287)
See also Table 10-1 that contains the key parameters that are reset by the correspond-
ing preset functions.
Remote command:
*RST on page 409
Set To Default
Resets the associated settings of the corresponding dialog or tab.
Preset this Parameter
Restores the default value of a single parameter.
Execute Factory Preset
Resets the instrument to its factory settings.
Restoring the (Default) Instrument Configuration