Rohde & Schwarz SMA100B - System Subsystem

Remote Control Commands
R&S
®
SMA100B
653User Manual 1178.3834.02 ─ 05
Example:
SOURce1:SWEep:MARKer:OUTPut:POLarity NORMal
three markers at 1 GHz, 2 GHz and 3 GHz
SOURce1:SWEep:FREQuency:MARKer1:FREQuency
1000000000
SOURce1:SWEep:FREQuency:MARKer2:FREQuency
2000000000
SOURce1:SWEep:FREQuency:MARKer3:FREQuency
3000000000
SOURce1:SWEep:FREQuency:MARKer1:FSTate 1
SOURce1:SWEep:FREQuency:MARKer2:FSTate 1
SOURce1:SWEep:FREQuency:MARKer3:FSTate 1
SOURce1:SWEep:FREQuency:MARKer:ACTive M03
Options:
R&S SMAB-B28
Manual operation: See " Frequency x " on page 181
[:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:FSTate
<FState>
Activates the selected marker.
Suffix:
<ch>
.
1 to 10
Marker
Parameters:
<FState> 0 | 1 | OFF | ON
*RST: 0
Example: See [:SOURce<hw>]:SWEep[:FREQuency]:MARKer<ch>:
FREQuency on page 652.
Options: R&S SMAB-B28
Manual operation: See " State " on page 181
13.17 SYSTem Subsystem
The SYSTem subsystem contains a series of commands for general functions which do
not directly affect signal generation.
SYSTem Subsystem