Rohde & Schwarz SMA100B - List Mode Settings

List and Sweep Mode
R&S
®
SMA100B
182User Manual 1178.3834.02 ─ 05
Marker Polarity
Sets the polarity of the marker signal.
The duration of the active signal is equal to the dwell time of a step.
Remote command:
[:SOURce<hw>]:SWEep:MARKer:OUTPut:POLarity on page 652
Active Marker
Boosts a specific marker signal so that it is output with higher voltage than all other
markers.
Remote command:
[:SOURce<hw>]:SWEep[:FREQuency]:MARKer:ACTive on page 652
6.6 List Mode Settings
The "List Mode" dialog contains all the functions and settings for creating and handling
lists with RF frequency/level pairs including the corresponding dwell times for generat-
ing the RF signal based on these values.
Access:
► Select "Sweep" > "List mode".
The dialog contains parameters for configuring the list mode processing, entering
list mode data and transferring data files from or to the instrument.
The remote commands required to define these settings are described in Chap-
ter 13.16.7, "SOURce:LIST Subsystem", on page 612.
● General Settings................................................................................................... 183
● List Mode Data Settings........................................................................................185
● Import/Export Settings...........................................................................................186
List Mode Settings