Getting Started
R&S
®
SMA100B
21User Manual 1178.3834.02 ─ 05
2 Getting Started
2.1 Preparing for Use
● Putting into Operation............................................................................................. 21
● Connecting USB Devices........................................................................................27
● Setting Up a Network (LAN) Connection.................................................................28
2.1.1 Putting into Operation
This section describes the basic steps to be taken when setting up the R&S SMA100B
for the first time.
Risk of injury due to disregarding safety information
Observe the information on appropriate operating conditions provided in the data sheet
to prevent personal injury or damage to the instrument. Read and observe the basic
safety instructions provided with the instrument, in addition to the safety instructions in
the following sections. In particular:
●
Do not open the instrument casing.
Risk of instrument damage due to inappropriate operating conditions
Specific operating conditions are required to ensure accurate measurements and to
avoid damage to the instrument. Observe the information on appropriate operating
conditions provided in the basic safety instructions and the instrument's data sheet.
Instrument damage caused by electrostatic discharge
Electrostatic discharge (ESD) can damage the electronic components of the instrument
and the device under test (DUT). Electrostatic discharge is most likely to occur when
you connect or disconnect a DUT or test fixture to the instrument's test ports. To pre-
vent electrostatic discharge, use a wrist strap and cord and connect yourself to the
ground, or use a conductive floor mat and heel strap combination.
Preparing for Use
To Next Page
Loading...
