R&S SU 4200 Function Test
6125.0226.12.01 2.10
2.7 Function Test
ATTENTION
The transmitter does not contain any parts the operator can repair. Only
properly qualified technicians are allowed to repair the radio. When
performing service procedures, follow the requirements of VDE 0701.
Function test\Function test "Name".doc
Function test
of the transmitter
LED CARR lights up after you press the PTT key. The transmitter is active
and can be modulated via audio input X5.
LED MOD flashes or lights up in rhythm with the voice signal.
You can listen to the modulated voice signal via the loudspeaker and the
headset. You can adjust the volume of the two separately.
If PTT keying is not activated at X5, you can also operate and activate the
radio in LOCAL mode. After you press the LOC key, you can power up and
modulate the transmitter via the headset.
The TX PARAMETER menu provides test functions for activating the
transmitter via keyboard operation (see chapter
3.4.7.4.1).
Last Page of Chapter 2\\Last Page of Chapter 2 "Radio".doc
To Next Page
Loading...
