Safety Precautions R&S SU 4200
2.1 6125.0226.12.01
2 Preparation for Use
This chapter
This chapter provides all information for:
Checking upon delivery
Installation into a 19" rack
Connection of peripheral equipment
Connection of mains and/or 28 V DC supply
Further
information
Chapter
3.1 contains an overview of the transmitter control elements,
indicators, etc.
Chapter
6.2 is an in-depth description of the radio’s interfaces.
2.1 Safety Precautions
WARNING
This is a class A product. In a domestic environment this product may
cause radio interference in which case the user may be required to take
adequate measures.
ATTENTION
Before putting the transmitter into operation, make the following checks:
Ensure that the ventilation holes are free of obstructions
Ensure that there are no unsuitable signal voltages connected to the
input
The transmitter’s outputs may not be overloaded and correct polarity
must be ensured
The radio may be damaged if the above checks are not performed.
ATTENTION
When fitting operating rooms and installing and operating electrical
equipment, the relevant national and international safety provisions and
regulations have to be adhered to.
The following safety instructions apply in particular:
IEC 364
VDE 0100
DIN 57100
These safety regulations deal with the following subjects:
Protective measures:
– Prevention of accidents
– Overvoltage protection
– Insulation of equipment
– Grounding
Type and laying of lines and cables
Provisions for operational facilities, rooms and equipment requiring
special handling
To Next Page
Loading...
