Basis Cabling R&S SU 4200
2.5 6125.0226.12.01
2.4 Basis Cabling
2.4.1 Rear Cabling
WARNING
Danger of electric shock!
The transmitter meets the requirements for Safety Class I in accordance
with DIN EN 61010-1/IEC 61010-1, e.g. all metal parts that can be touched
or accessed without removing the enclosure are connected to the protective
ground of the power supply network.
When connecting the instrument to the AC power supply, always use a
power cable with thermal connector and a socket with earthing contact.
WARNING
Danger of electric shock!
The radio contains a two-pole or neutral-conductor fuse. This means that
some parts of the radio will continue to be energized after the fuse has been
tripped.
When replacing the fuse, always disconnect the radio from the AC power
supply. Do not touch any live parts when performing service and
maintenance on the radio while the radio is switched on (by qualified
service personnel only).
Danger of el ectric shoc k\Danger of electric s hock "Name".doc
WARNING
Danger of electric shock!
A strong RF signal is present on antenna output socket X3 during
transmission.
Do not touch the antenna output socket on the rear of the radio during
transmission.
Danger of bur ns on the rear panel\ Danger of bur ns on the rear panel "Name ".doc
CAUTION
Danger of burns on the rear panel!
The rear panel is extremely hot around common antenna X3 and the power
supply unit (plugs X1, X2) owing to the radio's high transmit power. A label
indicates the hot area.
Do not directly touch the rear panel during or soon after operation.
External DC P ower Supply\ \External D C power supply "Name".doc
ATTENTION
The external DC power supply should deliver a short-circuit current of
I 30 A to ensure that the overcurrent protective device functions properly
in the event of a malfunction.
Note: To ensure that the radio works properly, it is required to supply an
earthing contact.
Rear Cabling\ Rear cabl ing "Radio".do c
To Next Page
Loading...
