Rohde & Schwarz SU 4200 - Installation with Blank Panel

R&S SU 4200 Installation into a 19" Rack
6125.0226.12.01 2.4
2.3.2 Installation with Blank Panel
Installation with Blank Panel\Installation with blank panel "Radio".doc
Installation with Blank Panel\\Installation with blank panel Transceiver STANDARD.doc
Fig. 2.2 Installation with blank panel
Installation
instruction
0.
1. Prepare the rack by installing the guide rails (see chapter
2.3.1).
2. Using the supplied screws, fasten the front handles of the transmitter
and the blank panel together, creating a rigid unit.
3. Screw-connect the included L-mounting brackets on both sides of the
rigid unit.
4. Slide the rigid unit into the rack so that the sides lie on the guide rails
(see chapter
2.3.1, instruction 3.).
5. Fasten the rigid unit to the rack with screws.
Note: To remove the radio, follow the reverse procedure.
2.
3
.
5
.