Rohde & Schwarz SU 4200 - Display Settings

Local Control (Local Mode) R&S SU 4200
3.23 6125.0226.12.01
3.4.3.5 Display Settings
Brightness and
contrast settings
It is possible to set up brightness and contrast anywhere in the menu by
pressing  or  cursor keys for approximately one second. A window with
a shifter appears. Using  or  cursor keys, the cursor will move to the
right, or left and luminance of the display will intensify, or reduce
accordingly. After approximately three seconds of inactivity, or by pressing
the ENTER key, the window disappears. The picture below shows the
brightness setting in the standard screen.
By pressing  or  cursor keys, it is possible to change the display
window. For example, if you press the  cursor key, the brightness window
is changed to the contrast window.
S U 4 2 0 0 2 1 : 0 4 : 1 3
M U B r i
g
h t n e s s 1 7
A
M
1
II
-- -- -- -- -- -- -- -- -- --
I
II
1 0 0 %
C B I T - S T
A
T U S O
K
Fig. 3.13 Brightness setting display
S U 4 2 0 0 2 1 : 0 4 : 1 3
M U C o n t r a s t 1 7
A
M
1
II
-- -- -- -- -- I -- -- -- -- --
II
5 0 %
C B I T - S T
A
T U S O
K
Fig. 3.14 Contrast setting display
Note: The settings will be stored temporarily if there is no key operation for
5 seconds. If the settings are not stored manually, the old values will be
recovered after the reboot.