R&S SU 4200 Configuring with the R&S ZS 4200
6125.0226.12.01 3.8
3.3 Configuring with the R&S ZS 4200
Configuri ng\\Configur ing "Name".doc
Configuri ng\\Configur ing transcei ver.doc
Introduction
The transmitter is equipped with a USB interface to allow communication
with the Service and Maintenance Tool R&S ZS 4200.
The following activities can be carried out:
Software download
Preset setup
Configuration
Enabling/Disabling of options
Inventory list
Note: For configuring with the R&S ZS 4200, see the Service and
Maintenance Tool R&S ZS 4200 software manual.
3.3.1 Factory Default Settings
Switching on
for the first time
The radio is preconfigured with the factory default settings. These settings
will be activated the first time the radio is switched on.
Switching on
in general
All radio parameters are stored in the non-volatile memory. The settings
active at the time of a power failure are restored when the radio is switched
back on.
Changing the radio
parameters
The radio is preconfigured with the factory default settings. These settings
can be changed via service PC with the Service and Maintenance Tool
R&S ZS 4200.
Properties
The properties of the parameters can have the following status:
A – Adjustment parameter (updated immediately after a change)
C – Cloning parameter
For more details please refer to the Service and Maintenance Tool
R&S ZS 4200 software manual.
Default setting\Default setting "Radio".doc
Parameters Value range Default value Properties
TX Audio Level –30 to +10 dBm 0 dBm A/C
TX Output Power Level Low 5 to 20 W 5 W A/C
TX Output Power Level Normal 5 to 50 W 50 W A/C
TX AM Modulation Depth 30 to 90 % 90 % C
TX Audio ALC Disabled/Enabled Disabled C
PTT Timeout 3 to 300 s,
0 (disabled)
30 s C
PTT Input Configuration Type I/Type II/RS Standard RS Standard C
5-Carrier Offset Disabled/Enabled Disabled C
ACARS Data Mode Disabled (Voice)/Enabled (ACARS) Disabled (Voice) C
To Next Page
Loading...
