R&S SU 4200 Local Control (Local Mode)
6125.0226.12.01 3.20
3.4.3 Screen Display
3.4.3.1 Start Display
Display parameter
The start display is an independent screen containing the radio name and
type. After booting the transmitter is started (see chapter
3.4.3.2).
Fig. 3.9 R&S Series 4200 logo
3.4.3.2 Boot Display
Display parameter
The boot display is an independent screen containing progress bar and
boot messages. The progress bar displays the current boot process state of
the transmitter.
Booting of the transmitter is completed when the standard operating display
appears (see chapter
3.4.3.3).
Boot displ ay\Boot displ ay "Name".doc
5
0
%
T X : I n i
t
H
W
O
K
Fig. 3.10 Boot display
In case of boot error
Boot errors are handled by a special error routine which allows the radio to
end the booting process and start the operation. This is indicated by the TX
CBIT 344. This error can be than read out via remote control.
Note: If the booting stops and the message “Boot Error” is displayed, switch
the transmitter off and on. In case the error persists, return the transmitter
to our service center for checking.
To Next Page
Loading...
