Rohde & Schwarz SU 4200 - Motor Tuned Telsa Filter

R&S SU 4200 Motor Tuned Telsa Filter
6125.0226.12.01 3.58
3.7 Motor Tuned Telsa Filter
Motor Tuned Tel sa Filter\Moto r tuned tels a filter "Radi o".doc
This chapter
The Telsa Automatic Cavity Filter is an optional hardware equipment and is
not contained in standard shipment. For using the Telsa Automatic Cavity
Filter together with transmitter, the filter must be connected to the RS-485
interface of the radio. In case of the transmitter R&S SU 4200, the filter
must be always connected to the TX module via X7. Additionally, the filter
has to be activated in the radio using the Service and Maintenance Tool
R&S ZS 4200 application.
Note: The transceiver supports the Telsa Automatic Cavity Filter (VHF
Automatic Cavity Filter T05120410).
Fig. 3.60 Transmitter with bus and filter
Note: If the filter is used, the standard RS-485 remote control interface
functionality of the radio is automatically disabled.
Note: Enabling the external motor Telsa filter will reduce the frequency
range. Please refer to the specification of the filter.
Note: If more than one radio is used, each radio needs its separate filter.
RS-485